XSPC Pressure and Leak Tester

The XSPC Pressure / Leak tester is designed to make your life easier, and your loop safer.

With this, you can do away with the old 24hr "wet" leak test, and safely install your loop into your case, and then pressure it up to check there are no leak points, before filling with liquid. Giving you a speedy peace of mind.

Our leak tester can also be used to ensure waterblock blocks / reservoirs etc are put back together correctly after a schedualled maintenance service or clean.

Features:
- Simple yet efficient pressure / leak testing for all loops and watercooling parts
- Detailed 1.4 bar pressure guage allowing you to perform all tests with one piece of kit
- Easy to use pressure release button
- Long 40CM Pressure tube for comfort when in use

Pressure Gauge Key:
0 – 0.4 bar (+/- 0.05 bar)
Low Pressure testing

0.4 – 0.6 bar (+/- 0.05 bar)
Waterblocks, Reservoirs and general loop testing

0.6 – 1.0 bar (+/- 0.05 bar)
Fittings and Radiator testing

1.0 – 1.4 bar (+/- 0.05 bar)
Over Pressure

Note: The pressure gauge key is designed for XSPC products. Check with the components manufacturer for maximum pressures.

Contents:
1x Aluminium hand pump
1x 1.4 bar Pressure Gauge
1x Pressure release button (red / pre-installed)
1x Flexible pressure tube
1x G1/4” adapter plug

Note: The pressure gauge is designed for use up to 1.4 Bar, excess over pressuring the gauge can and will damage it.