Watercool WCP D5 Pump and HEATKILLER D5 Top Bundle

This bundle includes the Watercool WCP D5 Pump - PWM and HEATKILLER D5 Top.

The WCP D5-PWM is a DC pump using the spherical motor design as developed by Laing. The only moving part in a spherical motor pump is a spherically shaped rotor/impeller unit, which is seated on an ultra-hard, wear-resistant ceramic ball.

The conventional shaft, shaft bearings, and shaft seals have been eliminated. The occurrence of bearing clearance – and the associated increase of noise – is not possible due to the principle involved. Consequently, the pump continues to work quietly throughout its entire service life.

The pump's rotation speed can be finely adjusted throughout a wide output range via a speed governor, which is integrated into the stator.

Pump Specifications:
Dimensions (L x W x H): 65 x 65 x 57 mm
Pressure head at 12 V: 3,7 m
Max. flow rate: 1500 l/h
Power supply: 4Pin Molex
Rotational speed monitoring: yes (via 3Pin Molex)
PWM: yes

The HEATKILLER D5-TOP is the perfect add-on for D5 pumps. Four G ¼“ threads allow for easy integration into the cooling loop with all common fittings. Non-used threads can be sealed with the included plugs.

Hydro-dynamically optimised channels make the pump work more efficient than with the original top.

A stainless steel mounting plate is included. This can be installed with a 90° variation as well, which makes mounting easy even in narrow PC cases. Alternatively, the plate can serve as a supporting base. A decoupling component made from rubber is separately available.

Specifications:
Dimensions block (without pump): 74 x 74 x 42 mm
Dimensions with base (without pump): 80 x 80 x 65 mm
Material: POM, polishes stainless steel
Weight: 350g
Threads: 4 x G1/4“