The Lamptron cu135 PCI ARGB & Fan Controller offers not only a wide functionality, but also a high compatibility. Up to six fans with or without PWM control and ARGB products with or without digital RGB LEDs run on it . The separate LCD display can be attached to PCI slots, the numerous information can then be admired through a transparent side panel made of hard or acrylic glass. Control is via an infrared remote control .
Maximum control of ventilation & lighting
The Lamptron CU135 PCI ARGB & Fan Controller offers nearly unlimited control over fans and ARGB lighting. With up to 36 watts of power per channel, there is almost no limit. The fan controller supports both fans with and without PWM. Power is supplied via 4-pin Molex and SATA connector. In total, up to six fans can be connected to the board of the controller.
Including LCD display and infrared remote control
The control of the lighting and the speed of the fan is done via the enclosed infrared remote control . For example, the fans can either be set to quiet mode at 40 percent or maximum mode.
Programmable thousands of colour for each single ARGB Led.
Mount on PCI slot with screw.
7.84 inch full color LCD display;
6 way fan port for PWM FAN ;
6 × ARGB (5vdg) interface;
6-way temperature sensor interface
touch screen control + remote control
- Dimensions (board) 121.5mm × 72.5mm × 21mm
- Dimensions (display): : 360mm × 70mm × 12.5mm
- Screen: 190mm × 50.4mm (screen)
- Compatibility: 3x PCI slots (display)
- Material: aluminum
- Fan channels: 6(max 36 W per channel)
- Voltage: stepless 0 - 12 V.
- 1x 6-pole molex
- 1x SATA
- 6x 2-pin temperature probe
RGB LED connectors:
- 6x 3-pin RGB (5VDG, up to 60 LEDs per channel)